ASTM C10

This specification covers natural cement. The chemical requirements and the physical requirements are detailed in the specification. The natural cement shall be subjected to fineness, autoclave expansion, time of setting, air content of mortar, and compressive strength tests using specified methods.

This abstract is a brief summary of the referenced standard. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

1. Scope

This specification covers natural cement.

Note 1—Examples of typical past uses of natural cement include unit masonry mortar, cement plaster, grout, whitewash, and concrete.

For properties where values are given in both SI and non-SI units, the values in SI units are to be regarded as the standard. Values in SI units shall be obtained by measurement in SI units or by appropriate conversion, using the Rules for Conversion and Rounding given in IEEE/ASTM SI 10, of measurements made in other units.

1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

2. Referenced Documents

C109/C109M Test Method for Compressive Strength of Hydraulic Cement Mortars (Using 2-in. or [50-mm] Cube Specimens)
C114 Test Methods for Chemical Analysis of Hydraulic Cement
C150 Specification for Portland Cement
C151 Test Method for Autoclave Expansion of Hydraulic Cement
C183 Practice for Sampling and the Amount of Testing of Hydraulic Cement
C185 Test Method for Air Content of Hydraulic Cement Mortar
C187 Test Method for Normal Consistency of Hydraulic Cement
C188 Test Method for Density of Hydraulic Cement
C191 Test Methods for Time of Setting of Hydraulic Cement by Vicat Needle
C204 Test Methods for Fineness of Hydraulic Cement by Air-Permeability Apparatus
C219 Terminology Relating to Hydraulic Cement
C305 Practice for Mechanical Mixing of Hydraulic Cement Pastes and Mortars of Plastic Consistency
C465 Specification for Processing Additions for Use in the Manufacture of Hydraulic Cements
C778 Specification for Standard Sand
C786 Test Method for Fineness of Hydraulic Cement and Raw Materials by the 300-m (No. 200) Sieves by Wet Methods
IEEE/ASTM SI 10 Standard for Use of the International System of Units (SI): The Modern Metric System

Index Terms

hydraulic cement; natural cement; specification; ICS Number Code 91.100.10

Citing ASTM Standards

[Back to Top]