ASTM D50

These test methods compile in one place, recommended procedures for analyzing inorganic colored pigments. These pigments are used extensively in paints, and for this reason their compositions are important to the formulators and user.

1. Scope

1.1 These test methods cover procedures for the chemical analysis of yellow, orange, red, and brown pigments containing iron and manganese. The test methods apply specifically to the following pigments: synthetic hydrated yellow iron oxide, yellow ocher, red and brown iron oxides, raw and burnt umber, raw and burnt sienna, and venetian red.

1.2 The analytical procedures appear in the following order:

1.3 &solely-SI-units;

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

2. Referenced Documents

C25 Test Methods for Chemical Analysis of Limestone, Quicklime, and Hydrated Lime
D1193 Specification for Reagent Water
D1208 Test Methods for Common Properties of Certain Pigments
D185 Test Methods for Coarse Particles in Pigments, Pastes, and Paints
D280 Test Methods for Hygroscopic Moisture (and Other Matter Volatile Under the Test Conditions) in Pigments
D562 Test Method for Consistency of Paints Measuring Krebs Unit (KU) Using a Stormer-Type Viscometer
E11 Specification for Wire Cloth and Sieves for Testing Purposes

Index Terms

brown pigment (iron and manganese); calcium; colored pigment; iron oxide; red pigment; soluble sulfate; yellow pigment

Citing ASTM Standards

[Back to Top]